Scenery 10mm: Flex Wall designed for resin printing.

Description

The Flex Wall was originally a design concept for an update to my castle (Now available) but I got a little carried away and turned it into a fully fledged stand alone castle wall thing. The pack comes with everything you need to make a wall or loop castle. Each section slots together at the towers, allowing angles between 90 and 270 degrees at each tower section. There is a gate section and a broken wall part, as well as hatches and roofs for the towers. The gap between the towers is just over 44mm, so a stand should fit comfortable between towers. The tower tops are 37mm wide, so you can place a stand on a tower (as long as you remove the roof). The widest part is just under 120mm, and the tallest part is just under 50mm.

All parts are hollowed and vented for resin printing, and are intended to be fully self supported, but printers vary, so please make sure that you are happy with the model before printing it.

Important: These files are for personal use only, unless you have specific written permission from Cromarty Forge Ltd you are not permitted to sell, rent, transfer, host on in any other way distribute these files or products derived from these files.